Инспекция двигателей и насосов
faster without stalls is critical to any drilling operation.
The demands placed on the drilling motor to achieve optimum
performance require the proper fit between the rotor and the
stator in the power section. Gagemaker’s Power Section Gages
ensure this fit meets these specifications.
with shoes and laptop With Gagemaker’s Stator Bore Diameter
Gages, Rotor Major Diameter Gages, and Rotor Minor Diameter
Gages, you are armed to maintain the quality of the power section
you produce. With this arsenal of inspection gages, there’s
not a motor or pump out there that can’t be inspected.
of Gagemaker’s electronic Stator Bore Gages provides data collection
and data storage options of bore measurements. The gage is supplied
with a notebook computer which provides the ability to enter
a serial number and store inspection data as a file for future
reference. The data can also be ported through a wireless link
to a central computer for further processing.
accurate, easy to use, the Gagemaker Stator Bore Gages ensure
your quality levels remains at the highest level possible.
SBG series of gages determines a precise stator/rotor match
by measuring the variation in bore diameters. Attaching or removing
different height extension shoes provides the gage a range of
diameter flexibility. The gages address any pitch or lobe configuration.
SBG-3000 measures the minor diameter at each lobe in the range
from .950” to 1.875” and up to 7.500” with additional measurement
shoes. A floating roller traverses the lobe crest as the gage
is moved through the bore capturing each minor peak. The data
is transmitted through Bluetooth communication to the computer
as it is detected. The readings may be paused and repeated as
desired. The gage has .050” of travel and requires measurement
shoes sized close to the minor diameter of the stator. Crescent
style shoes are available for a specific diameter between the
range .950"(24.13 mm) to 1.875"(47.625 mm), while
modular style shoes are available for a range of 1.875"(24.13
mm) to 7.500"(190.5 mm). A specific diameter setting ring
is also required for each measurement shoe purchased.
SBG-5000E measures diameters from 1.500” – 2.000”. Additional
shoes are available for inspecting diameters larger than 2.000”
and up to 7.500”. The SBG-5000E includes three extension shoes,
an interface box, a computer, measurement software, cables,
and setting standard base (standard not included). Setting standards
are sold individually and separately.
SBG-5000A, SBG-5000D & ABG-5000E Extension Shoes and Risers
style of extension shoe depends on the diameter range being
measured. Shoes are offered in several lengths depending on
the pitch of the stator lobes. It is important that the shoe
length be long enough to contact a minimum of two points on
the bottom and one point on the top pad.
shoes are available as special request. Contact Gagemaker for
SBG-5000D & ABG-5000E Setting Standards
Setting standards do not need to be sized to the exact bore of the stator’s bore. As long as the size of the standard is within the measurement range of the gage, it can be used to preset the gage. Custom sizes and round standards are available as special requests.