Глубина
Depth
Наши цифровые приборы позволяют измерять внутренние и внешние
канавки и проточки, как на муфтах, так и на нипелях или аналогичных
поверхностях. Прибор Серии DG-1000 поставляется со стандартной
штангой длиной 12" или 20" с различными диапазонами
измерений: 0 – 8”, 0 – 12", 0 – 18", and 0 – 24".
The
standard gage (DG-1000 Series) is supplied with a 7” extension
arm and a 0° and 45° contact point holder for use with any #4-48
threaded contact point (one .072" contact point (T072)
supplied unless otherwise requested). Longer extension arms
and other contact point configurations and adapters are available
upon request.
The
12" (DG-1200 Series) and 20" (DG-2000 Series) gages
include one double sided blade contact instead of a contact
point and a contact point holder. Digital depth gages do not
requires a setting standard.
The gage is preset to zero on any flat surface and then applied
to the product. Actual length measurements display on the gage’s
digital readout.
Torgue Shoulder Lenght
Torgue Shoulder Lenght
Both
the TS-1000 and TS-4000 series of gages accurately measure the
distance between the primary and secondary torque shoulders
on both internal and external threaded connections. Used industry
wide to measure the shoulder-to-shoulder distance on premium
tool joins and the face-to-seal location on premium couplings,
Gagemaker TS gages are also perfectly suited to locate grooves
from various datum surfaces.
All
TS gages require a setting standard. The gage is preset to the
desired dimension and deviation is read from the gage’s dial
indicator. Standards are sold separately.
The
TS-1000 is supplied with a 6' extension arm. A 45° contact point
holder for use with any #4-48 threaded contact point is also
supplied. Longer extension arms, other contact points, and adapters
are available upon request.
TS-4000
gages require taper specific wear pads that are sold separately.
|